Installation Manual
Table Of Contents
- 1 Important Information
- 2 Safety Instructions
- 3 Introduction
- 4 Technical Data
- 5 Installing
- 5.1 Mounting
- 5.2 Unmounting
- 5.3 Opening the Case
- 5.4 Closing the Case
- 5.5 Cabling
- 5.6 Grounding and Shielding
- 5.7 Connecting Power Supply
- 5.8 Ethernet Interface
- 5.9 RS-485 Host Interface
- 5.10 RS-232 Host Interface
- 5.11 DIL switch selector
- 5.12 RS-485 for extension modules
- 5.13 Wiegand Interface for Card Readers
- 5.14 Connecting Relay Outputs
- 5.15 Connecting Analog Input Devices
- 5.16 Tamper Protection
- 6 Operating
- 7 Appendix
38 en | Installing AMC2 4W
| V 7.6 | 2008.12 Installation manual Bosch Sicherheitssysteme GmbH
5.10 RS-232 Host Interface
The AMC2 offers an RS-232 serial interface to connect a host
computer or serial modem.
Figure 5.15 Location of the RS-232 serial interface
As the AMC2 controller is conceptionally a PC, it is not possible
to connect them directly using normal cables. Use instead a null
modem or “crossover” cable. A complete connection diagram of
the RS-232 host interface is shown in Figure 7.2.
!
WARNING!
Cable length between two RS-232 COM serial interfaces must
not exceed 15 meters (45 ft).