Installation Manual
Table Of Contents
- 1 Important Information
- 2 Safety Instructions
- 3 Introduction
- 4 Technical Data
- 5 Installing
- 5.1 Mounting
- 5.2 Unmounting
- 5.3 Opening the Case
- 5.4 Closing the Case
- 5.5 Cabling
- 5.6 Grounding and Shielding
- 5.7 Connecting Power Supply
- 5.8 Ethernet Interface
- 5.9 RS-485 Host Interface
- 5.10 RS-232 Host Interface
- 5.11 DIL switch selector
- 5.12 RS-485 for extension modules
- 5.13 Wiegand Interface for Card Readers
- 5.14 Connecting Relay Outputs
- 5.15 Connecting Analog Input Devices
- 5.16 Tamper Protection
- 6 Operating
- 7 Appendix
AMC2 4W Installing | en 31
Bosch Sicherheitssysteme GmbH Installation manual | V 7.6 | 2008.12
5.7 Connecting Power Supply
Connect the power supply to the POWER 7-pin pluggable screw
connector on the upper case. Refer to Table 7.3 for a complete
diagram.
Figure 5.7 Location of the power supply connector
Connect an external power supply (10 - 30 Vdc) for the AMC2
device at pin 1 (positive) and pin 3 (negative) of the pluggable
screw connector.
If an uninterruptible power supply (UPS) is used, the relay
output for power good signals from the UPS is connected to the
following pins:
– pin 4 and 7 for power good AC
– pin 5 and 7 for power good Battery
– pin 6 and 7 for power good DC
Otherwise these pins must be short-circuited.