Data Sheet

Output Programming
Each output can be independently programmed for
Steady, Temporal Code 3, or Strobe synchronization.
All outputs can be programmed for Input to Output
Follower mode.
Paralleling Outputs
An individual output of 4 A can be obtained by
paralleling two outputs.
Horn and Strobe Synchronization
The two-wire synchronization mode works with the
Gentex Commander GOS Sync Mode 3, 4 and ST/HS
series, the System Sensor SpectrAlert series of horns,
strobes, and horn strobe combinations, and Cooper
Wheelock horns, strobes, and horn strobe
combinations to provide a means of synchronizing the
temporal-coded horns, synchronizing the flash timing
of the strobe, and silencing the horns of the horn
strobe combination over a two-wire circuit while
leaving the strobes active.
Notice
The AL802‑WAL will synchronize only the horns,
horn strobes and strobes that contain
synchronization capability.
Certifications and approvals
Altronix Corp. holds these Listings and Approvals:
NFPA Complies with NFPA 72
Region Certification
USA UL UOXX: Control Unit Accessories, System
(UL864)
FM AL802-WAL
CSFM see our website
Parts included
Quant. Component
1 NAC power extender
1 AL802 logic board (AL800LGK9E)
1 Enclosure (red)
1 Cam lock
1 Open‑frame transformer
1 Set of battery leads
1 Hardware pack
1 Literature – Installation Guide
Technical specifications
Mechanical Properties
Dimensions: 15.5 in. high x 12 in. wide x 4.5 in. deep
(39.4 cm high x 30.5 cm wide x 11.4 cm deep)
Weight: 17 lbs (7.7 kg)
Trademarks
All hardware and software product names used in this
document are likely to be registered trademarks and
must be treated accordingly.
Ordering information
AL802‑WAL NAC Power Extender (8 A)
8 A remote power supply/battery charger that can be
connected to any 12 VDC or 24 VDC FACP
Order number AL802-WAL
Accessories
AL800LGK9E Logic Board
Replacement board used with the AL802‑WAL or
AL1002WAL NAC Power Extenders; mounts in
enclosure
Order number AL800LGK9E
2 | AL802‑WAL NAC Power Extender (8 A)