Operation Manual

15
Specification subject to change
What is especially recommended before using an
accu or a cordless power tool for the first time?
The operating instructions should be read carefully
since accu technology is subject to constant technical
changes which might require a different type of han-
dling.
How should nickel-cadmium accus be stored:
charged or uncharged?
It doesn’t matter, since they become discharged after a
while anyway.
Should nickel-cadmium accus always be dis-
charged completely or should they be charged in
every break at work?
If possible, discharge them completely before recharg-
ing them.
What is a total discharge?
A total discharge can happen for example: if the switch
of a power tool is locked in the on position by foreign
particles and power is drawn from the accu after it has
been completely discharged - or if the battery is left in
the charger for prolonged periods with the mains sup-
ply turned off.
Does total discharging harm the accu?
Yes.
Can charged accus deliver the same power in sub-
zero temperatures?
No. Accus require a minimum temperature for opera-
tion. This can be done by transporting them in a warm
place (pockets) to the work site.
Service
www.bosch-pt.com
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham-Uxbridge
GB-Middlesex UB 9 5HJ
✆ Service ......................... +44 (0) 18 95 / 83 87 82
Fax Service ....................... +44 (0) 18 95 / 83 87 89
✆ Advice line ..................... +44 (0) 14 49 / 83 87 82
Fax .................................... +44 (0) 14 49 / 83 87 89
Ireland
Beaver Distribution Ltd.
Greenhills Road
IRL-Tallaght-Dublin 24
✆ Service ............................... +353 (0)1 / 45 15 211
Fax ......................................... +353 (0)1 / 45 17 127
Australia
Robert Bosch Australia L.t.d.
RBAU / SPT2
1555 Centre Road
P.O. Box 66 Clayton
AUS-3168 Clayton / Victoria
✆ .......................................... +61 (0)1 / 800 804 777
Fax ....................................... +61 (0)1 / 800 819 520
www.bosch.com.au
E-Mail: [e-mail]
New Zealand
Robert Bosch Limited
14-16 Constellation Drive
Mairangi Bay
Auckland
New Zealand
✆ .............................................. +64 (0)9 / 47 86 158
Fax ........................................... +64 (0)9 / 47 82 914
Declaration of Conformity
Measured values determined according to
2000/14/EC (1.60 m height, 1 m distance away) and
EN 50 144 .
Typically the A-weighted noise level of the product is:
sound pressure level 75 dB (A); sound power level
86 dB (A).
The typical hand/arm vibration is below 2.5 m/s
2
.
We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents: EN 774, EN 50 144
according to the provisions of the directives
89/336/EEC, 98/37/EEC, 2000/14/EC.
2000/14/EC: The guaranteed sound power level LWa
is lower than 89 dB (A). Conformity assessment
procedure according to Annex V.
Leinfelden, 01.08.2001.
Dr. Gerhard Felten Dr. Eckerhard Strötgen
Robert Bosch GmbH, Geschäftsbereich Elektrowerkzeuge