Specifications

6 720 644 063
Operation instructions
35
5.4 How to Use (Using the remote controller)
Setting and Using the Water Heater
Fig. 40
1 Burner On Indicator
2 Priority Indicator
3 Temperature Setting
4 Setting Buttons
5 Power ON/OFF Button
6 Flow Meter Alarm Set Button
• Burner ON Indicator
When burning, the indicator is lit
• Priority Indicator
When this indicator is lit,the hot water temperature-
can be set
• Temperature Setting
(Ex.: 110°F (40°C))
• Flow Meter Setting
The display will flash after hitting the flow meter alarm
set button
• Error Code
A number will flash if a failure occurs
• Setting Buttons
For setting the hot water temperature, the flow meter
alarm, and other settings
• Power ON/OFF Button
For turning theheater on and off
• Flow Meter Alarm Set Button
For setting the flowmeter alarm.
Starting with the Power OFF
1. Check that electrical power is connected
The temperature will be displayed on the remote control
thermostat.
i
The illustration below shows the remote
controller display. What is actually dis-
played depends on how the water heater
is set.
USA REMOTE CONTROL
(PART N# BRC01US)
CANADA REMOTE CONTROL
(PART N# BRC01CA)
i
Before use, remove the protective sheet
from the remote controller surface.
Danger: To prevent scalding
Hot Water Heater temperatures over
125°F (52°C) can cause severe burns
instantly or death from scalding.
Danger: To prevent scalding
Children, disabled and elderly are at the
highest risk of being scalded. Feel water
temperature before bathing or shower-
ing.Temperature limiting valves are avail-
able (installer supplied).
Danger: To prevent scalding
When setting the unit to130°F (60°C) or
higher, the temperature display will flash
for 10 seconds and emit a tone as a high
temperature warning.
Danger: To prevent scalding
Take caution when using the unit again
after setting to 125°F (52°C) or higher.
Always check the set temperature be-
fore use.