Specifications

7
The third and final bank of LEDs are located
at the bottom right corner of the controller,
as shown in Figure 4, and indicate whether
each of the five (5) Binary or Digital Outputs
(BO) are energized or not.
DIP and Rotary Switches
Two sets of switches can be found on the
controllers; they must be set properly to
allow correct operation of the unit.
The first set is a bank of rotary switches
(shown in Figure 5), located on the top, left-
hand corner. These switches are used to set
a unique address for the controller when it is
connected to a network. The address is
represented by a two-digit number (00-99)
setting with the rotary switches; the top
rotary representing the tens digit and the
bottom rotary representing the ones digit (as
shown in Figure 6).
The second set of switches is the bank of
DIP switches located on the top, right-hand
corner of the controller. The purpose of this
switch bank is two-fold:
Figure 5 – Controller Address Rotary DIP switch
Figure 6 – Rotary switches
Figure 7 – DIP Switches
IMPORTANT:
Controllers must be
addressed correctly
for multiple units to
work on a network.