Specifications

4
The Zone Controller
The Zone control board, also known as DDC
(Direct Digital Controller) and shown in
figure 1, is used in most configure-to-order
applications.
It is BACnet® native, which makes it flexible
and easy to integrate into existing Building
Automation Systems (BAS). The main
difference between the FHP 560 and the
FHP 583 is that the 538 has an Analog
Output (AO) plug above the Binary Output
(BO) plug.
The controller is programmed from the
supplier or at the factory with software
versions that suit the different applications
FHP offers. User settings such as the time
and test and balance set points should be
set up during the installation and
commissioning process at the job site.
Figure 1 – FHP 560 Controller