Specifications

Personal Security Data Book |69
call to the PS-Micro control desk, giving the operator the
location of the mobile holder. The last two locations
visited, current and previous are available. This feature is
ideally suited to direct ‘rescue’teams to the location of the
mobile holder.
Guard Tour
In systems with location detection, the desk can be set to
print all location information of selected PS-Micro
mobiles, even though logging is set to OFF. Guard Tour
can be enabled or disabled for each mobile channel of the
control desk.
DP6000 Paging facility
With the addition of a DP6000 paging facility, the
operator in the event of an alarm procedure can re-route
an alarm call with alarm information to the operator’s
paging receiver during manned or unmanned operation
or to a colleague paging receiver or even to group(s) of
paging receiver holders acting as a rescue back-up team.
Programming the desk
The programming of the desk and the setup of the
mobiles are done using the PS-Micro desk utility software
package running on a temporary PC/Laptop computer.
The desk connects to the PC/Laptop using its built-in
RS232 interface.The RS232 interface can also be
connected to a printer to print out a choice of logged
operator events and alarm actions (see Logging).A SET-
UP menu on the desk allows the operator to select and
set-up USER and SYSTEM operational parameters, as
well as performing a TEST procedure on the desk itself
and assigned pagers.
GG
GGGGG
MOB 01 MOB 02 MOB 03 MOB 04 MOB 05
22-11-99
16:30
GGG
not act guard on RETURN
22-11-990001 PRESENT
16:33
LOCATION 003
Date and Time
MOBILE-
Address
Mobile status
Current/Previous location
Mobile operational settings
CHANNEL INFORMATION display
R
RRRRR
G
B1
B2 B3
BM
B4 B5
MANUAL ALARM PREVIOUS LOCATION 003
OOO1 LOCATION REROUTE NEXT
Audible priority 1 and 2 alarm
ALL LEDs flashing RED
ALARM RECEIVED mode
CURRENT
Table 1. Status of Channel LEDs in STAND-BY mode
Desk Status Channel LED LC-display
Mobile in use, NO alarms GREEN (steady) Mobile ID
Mobile in use PRIORITY 3 alarm RED (flashing) Mobile ID
Mobile in use PRIORITY 1 & 2 alarm RED (flashing) Mobile ID (flashing)
Mobile in storage rack OFF Mobile ID
Mobile de-activated OFF Blank
Table 2. Status of mobiles in Information display
Mobile status Description
PRESENT The PS-Mobile has reported itself ‘PRESENT’ to the system and is in operational use.
WAIT FOR SCAN The desk is waiting for a ‘check-in’ scan call from the relevant PS-Mobile. The ‘check-in’ time is
defined by your system installer. If the desk does NOT receive a ‘checkin’ scan call within this time-
frame’ an alarm procedure is raised
NOT ACTIVE The PS-Mobile has been disabled.
ABSENT The PS-Micro mobile has been place in to its charging/storage rack.
ALARM The PS-Micro mobile is in an alarm condition
GS TEST The PS-Micro mobile is performing a GS Test procedure.
LOW BATTERY The PS-Micro mobile reports ‘LOW BATTERY’ state