Operator`s manual

LightCycler® 480 Gene Scanning Software

Performing Gene Scanning Analysis

�

Selecting a new genotype group from the New Call list and clicking Apply changes all

affected samples currently displayed in the graphs to the new name.

Selecting Auto Call from the New Call list (and clicking Apply) causes all affected

samples currently displayed in the charts to revert to their previous (automatically

determined) name.

All manually modiﬁed calls are marked with an asterisk in the Results table and

in reports.

You cannot assign a new call to negative controls. When in-run melting stan-

dards are used, you cannot assign a new call to them. If you attempt to apply a

new call to a selection that includes an in-run melting standard or control, the

software will warn you that the selection includes in-run standards or controls

that cannot be changed, and asks you if you want to continue. If you choose to

continue, the software will apply the changes to all samples except the in-run

standards and controls. If you choose not to continue, the operation will be can-

celled.

■