User guide

Security System User’s Guide

LED Command Center User’s Guide

Remote Arming with Telephone, Area 1

I can perform this command.

I cannot perform this command.

This function controls the built-in telephone arming feature for Area 1.

When enabled, the panel answers the phone on the programmed ring

count.

When the panel answers the phone:

• If the panel is All or Part On, it sounds three beeps and starts the

handshake tone for remote programming.

• If the panel is Off, it sounds one short beep, waits approximately

three seconds, and then sounds one long beep. Press and hold the

[5] key* for two seconds immediately after the first short arming beep

and before the long beep begins.

• The panel will arm if it detects a [5] key press from the telephone (All

On with Delay, faulted points are force-armed). The panel sounds

three beeps (new armed state) and then hangs up.

* If arming from a cell phone, quickly press the [5] key three times. If

pressing and holding the [5] key for two seconds from a house (land-line)

phone does not produce a tone long enough to arm Area 1, retry by quickly

pressing the [5] key three times.

Remotely disarming the panel cannot be done with a telephone.

Remote Program (Cmd 43)

I can perform this command.

I cannot perform this command.

This command forces the system to connect to your security company’s

remote PC computer for programming alterations via the telephone line.

Only use this feature under the direction of your security company.

1. Ensure that the system is turned off (All and Part indicators are off).

2. Press [Cmd] + [4] + [3]. The Command Center may prompt you to

enter a valid passcode by flashing the Cmd indicator.

3. Enter your passcode. The Command Center will emit a single-beep

tone, indicating that the remote programming session has begun.

When the session is completed, the Command Center automatically

exits this command.