User guide

Security System User’s Guide

LED Command Center User’s Guide

All Areas Off (Cmd 81)

I can perform this command.

I cannot perform this command.

Depending on the areas assigned to your authority level, this command

allows you to turn off all areas at the same time when the system is split

into more than one area.

1. Press [Cmd] + [8] + [1]. The Command Center may prompt you to

enter a valid passcode by flashing the Cmd indicator.

2. Enter your passcode if necessary. The Command Center turns off all

areas at the same time.

Auto-Forward On/Off (Cmd 82)

I can perform this command.

I cannot perform this command.

This command allows you to turn on or off the auto-forward feature as

necessary.

1. Press [Cmd] + [8] + [2]. The Command Center may prompt you to

enter a valid passcode by flashing the Cmd indicator.

2. Enter your passcode if necessary. The Command Center sounds the

valid entry tone.

3. Press [1] to turn auto-forward on, or press [2] to turn auto-forward off.

• Point Indicator 1 On Solid: Auto-Forward ON (Point Indicator 2

flashes)

• Point Indicator 2 On Solid: Auto-Forward OFF (Point Indicator 1

flashes)

4. Press [Cmd] to exit this command.