User guide

Security System User’s Guide

LED Command Center User’s Guide

Select Watch Points (Cmd 63)

I can perform this command.

I cannot perform this command.

The Watch feature gives you the ability to “watch” points when the system

is off. For example, parents with small children may want a tone to sound

whenever a door or window is opened as a way of monitoring the location

of the children.

Once you have decided how your system responds to watched points

(see page 37, “Select Watch Tone”), you need to decide which of the

points in your system will be watched. Use this command to tell your system

which points to watch. You cannot watch 24-hour or fire points.

Choosing which points to watch depends upon your goals. If you have

small children, you may choose to watch points of entry and exit. Each

time a watch point is faulted (a door or window is opened), the Command

Center responds as programmed For example, you may tell your system

to produce a short beep when a watch point is faulted.

1. Make sure that your system is off (All and Part indicators are off).

2. Press [Cmd] + [6] + [3]. The Command Center may prompt you to

enter a valid passcode by flashing the Cmd indicator.

3. Enter your passcode if necessary. The Command Center displays all

points that are currently being watched (Watch On).

• Point Indicator On Solid: indicates point(s) already being “watched.”

• Point Indicator Flashing: indicates point(s) available to be “watched.”

4. Enter the point number that you want to watch followed by the [

∗] key

(for example, press [5] + [

∗] to watch Point 5). Repeat this step to

select all the points you want to watch. To turn Watch Mode off for a

point, enter the point number followed by the [

∗] key (for example,

press [5] + [

∗] to turn Watch off for Point 5).

1 2 3 4 5 6 7 8

9 10 11 12 13 14 15 16

All

Cmd

Part

Status

5. Press [Cmd] to exit this command.