User guide

Security System User’s Guide
LED Command Center User’s Guide
46840C Page 22 Copyright © 2002 Radionics
Date and Time (Cmd 45)
I can perform this command.
I cannot perform this command.
Use this command to program the system’s date and time.
1. Ensure that the system is turned off (All and Part are not illuminated).
2. Press [Cmd] + [4] + [5]. The Command Center may prompt you to
enter a valid passcode by flashing the Cmd indicator.
3. Enter your passcode. The Command Center lights Point 1 on the
display.
4. Enter the date and time using the MM/DD/YY, HH:MM format.
___
M
___
M
___
H
___
H
Month of
the year
Day of
the month
Current
Year
Hour of
the day
Minute of
the hour
/ ___
D
___
D
___
M
___
M
___
Y
___
Y
/ :
The Command Center lights points 1 through 6 (each point represents
a digit to be entered) for the date and points 1 through 4 for the time.
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
All
Cmd
Part
Status
Note: The time should be entered in 24-hour format (8:00 pm = 20:00).
5. After you enter the date and time, the Command Center sounds a
long beep and automatically exits the Date and Time command.
In the event of a power cycle (power is lost to the system and
then restored), the panel takes the last event in the log and uses
that as a starting point for the time and date. It will then alert you
to enter the current time and date.