User guide

Security System User’s Guide

LED Command Center User’s Guide

How Your System Reports Alarms

Your security system may be programmed to automatically disconnect

your telephone when sending reports to your security company. Once the

report is complete, the system returns the telephone to normal operation

(verify with your installing company).

Your system makes repeated attempts to send reports to your security

company. If your system fails to report, the Command Center signals a

system trouble. See page 29, “Check System Troubles,” for more information

on determining the nature of the trouble.

If your telephone service is interrupted, your security system

cannot send reports to your security company unless it has an

alternate means of transmitting them.

Silence Alarms

When there is an alarm, the alarm tone sounds and the point(s) in alarm

illuminate on the display (up to Point 16). If you enter your passcode before

the system dials your security company, the alarm report is aborted.

1. Enter your passcode to silence the alarm and turn the system off (if it

was turned on). An alarm report will be sent if it is not acknowledged

in time.

2. Press and hold the [Cmd] key to remove the alarms (flashing point

numbers) from the Command Center display. See “View Alarm

Memory,” page 30, to see which points caused the alarm.

1 2 3 4 5 6 7 8

9 10 11 12 13 14 15 16

Part

All

Cmd

Status

Keypad Adjust (Cmd 49)

I can perform this command.

I cannot perform this command.

Use this command to adjust the Command Center’s sounder volume.

1. Press [Cmd] + [4] + [9]. Enter your passcode if necessary.

2. To adjust the Command Center’s sounder volume, press and hold

the [

∗] key, and then press [1] to increase the volume or [4] to decrease

the volume.

3. Press [Cmd] to exit this command function when all adjustments are

made.