User manual

NYCe4000 Standard Housings and Accessories Manual Bosch Rexroth AG 23/164
NY4012: 1 Drive Slot System Housing
4.4 NY4120 / NY4140 drive power connector
The NY4120 / NY4140 drive power connector is used to connect the drive power
supply. The drive module has a separate drive power connector.
Connector type on the backplane: male, 5 pins, Phoenix, MSTBV 2,5/ 5-GF-5,08.
Mating connector on the cable is one of the following:
 MSTBC 2,5/ 5-STZF-5,08 order code 1809763, provided with crimp barrels
MSTBC-MT 1,5-2,5 order code 3190551 suitable for factory wiring only, rated
300V, 10A (exception 36.9.3 in UL 508C).
 QC 1/ 5-STF-5,08 suitable for field wiring, order code 1883381.
The following NY4120 / NY4140 drive power connector is available on the
backplane:
 Drive Power 0 : drive power connector for drive module slot 1
Fig. 6 NY4120 / NY4140 drive power connector (backplane) pinout
The connector pin assignment is given in Table 4.
Wiring: shielded cable, wire diameter AWG14 (10 A).
Table 4 Pinout NY4120 / NY4140 drive power connector
Pin Pin name Function
1 DR_PWR+ + Drive power supply module x
2 DR_PWR+ + Drive power supply module x
3 SHIELD Cable shield
4 DR_GND Ground drive power supply module x
5 DR_GND Ground drive power supply module x
Note:
DR_GND must be connected to the same potential as SHIELD (safety ground),
not at the node side of the cable, but at the power supply.