Specifications

4.0 Maintenance and Repair
4.1 Inspection Checklist
5.0 Document Control
Any changes or updates to this document must be recorded and maintained.
Initially Created By: The Office of Safety and Risk Management
Date: September 2011
Consultation:
 Studio Managers and Technicians
 Program Chairs and faculty
Date:
January-April 2013
April – May, 2013
Approval By: VPFA and VPA
Date: September, 2013
Review and Revisions Made By:
Date Revised:
Changes Made(indicate sections):
Revisions Approved By:
Date of Approval:
DAILY
✔
Ensure that the power cords are free of frays and damage.
Ensure that the saw is secure with no loose parts.
Ensure that all bolts/adjustments are tight.
Ensure that the tool foot is in good condition.
Ensure that the blade and teeth are free of defects and dullness and centered between the guides-replace
if necessary-use gloves.
Ensure the guides are in good condition and properly adjusted.
Ensure that the power cords are free of frays and damage.
WEEKLY ✔
Check the carbon brushes-replace if worn.
Clean blades.
MONTHLY ✔
Check the guide roller for wear and lubricate with a drop of oil. Replace if necessary after a long period.
Clean the guides with a solvent and then lubricate.
ANNUALLY ✔
Clean all plastic parts with a soft damp cloth.
Clean out the ventilation slots.
Inspect entire tool and perform maintenance as required.