Specifications

2. Cutting
Picture 4
a) Beware of the extremely sharp knives.
b) Stand right in front of the machine for accessibility to the foot pedal.
c) Lower the pedal at a moderate speed, and make the cut.
d) Ensure you have a secure footing on the foot pedal (see picture 4).
e) Never stand on the foot pedal.
f) Once you release the foot pedal the knife will return to the starting
position.
g) To give another cut, move the knife block (see picture 5) a little forward
using the lever knob (see picture 6) and move it further to the right.
h) Make desired cuts until the mould has been cut in two parts.
i) When making the final cut, ensure the lever knob is all the way to the last
notch.
j) Extreme caution must be exercised to avoid cuts from the blade.
Picture 5
Picture 6
3. After cutting
Picture 7
a) Once done release the foot pedal.
b) Remove your material form the guillotine.
c) Adjust the pedal height stop (see picture 7) to lock the knives in the lower
position when the machine is not used.
d) Clean the guillotine area upon completion of the task - Never clean the
machine while it is being used.
e) Remove the chips from the surrounding area with a brush - never by hand.
f) Sweep the surrounding floor.