Specifications

3.2 Equipment Specific Safe Operating Procedure (SOP)
1. Before cutting
Picture 1
a) Put on required PPE
b) Mark the desired area(s) to be cut. Don’t cut a work piece with flaws, nails,
or other foreign objects-to prevent personal injury from flying material.
c) Loosen the hand levers to adjust the angle of the fence according to the
measuring scales on the table (see picture 1).
d) For a double mitre cut, adjust the fence angle at 45 degrees. For a single
mitre cut, set it to 90 degrees.
e) If cutting longer materials ensure the stop block is in place and locked in
position (see picture 2).
f) Place the material on the table against the fence (see picture 3)- don’t
place multiple moulds at once.
g) Line up the mark with the blade and position it in place.
h) Make sure your fingers are not under the knife.
i)
Picture 2
Picture 3