Specifications

• DOK-DIAX01-MAIN+2AD+1M-ANW1-EN-E1,44 • 07.97
9
Contents
Contents
1. Commissioning INDRAMAT AC Main Spindle Drives 13
1.1 Summary of Main Spindle Drive Systems......................................13
1.2 Safety Guidelines ...........................................................................16
1.2.1 Notes on Protecting Personnel ......................................................16
1.2.2 Guidelines on Protecting Equipment..............................................17
1.2.3 Guidelines on Protecting the Machine ...........................................17
1.3 The Equipment Required ...............................................................18
1.4 Main Spindle Drives with KDA or TDA ...........................................19
1.4.1 Mains Supply Requirements ..........................................................19
1.4.2 Checks with the Equipment Switched Off ......................................19
1.4.3 Checks with the Signal Conditioning Powered Up.........................20
1.4.4 Checks after the Power Infeed has been Connected ....................21
1.4.5 Initial Start-Up ................................................................................22
1.5 Main Spindle Drives with RAC Controllers ....................................23
1.5.1 Mains Requirements ......................................................................23
1.5.2 Checks with the Equipment Switched-Off......................................23
1.5.3 Checks with Mains Supply Connected/Power Circuits ......................
Disconnected .................................................................................24
1.5.4 Connecting the Power Infeed.........................................................26
1.5.5 Initial Start-Up ................................................................................26
2. Operating the Controllers 27
2.1 The Control Panel ..........................................................................27
2.2 Main Spindle Drive in Operating Mode ..........................................28
2.2.1 Displaying the Internal State Variables of the Drive.......................29
2.2.2 Outputting the Drive Internal State Variables for Analogue
Output N .........................................................................................29
2.3 The Main Spindle Drive in Parameter Mode ..................................31
2.3.1 Parameter Value Quick-Check.......................................................31
2.3.2 Reading the Parameters ................................................................32
2.3.3 Changing the Parameters ..............................................................33
2.3.4 Displaying the Software Version ....................................................35
2.3.5 Duplicating the Parameters............................................................35
2.3.6 Loading Operating Parameters via Serial Interface .......................36
3. Controller Functions 37
3.1 Drive "Ready" State .......................................................................37
3.2 Speed Command Value .................................................................38
3.2.1 Analogue Speed Command Value (option)....................................38
3.2.2 Digital Speed Command Value (option) .........................................41
3.3 Main Spindle Speed Signals ..........................................................44