Specifications

• DOK-DIAX01-MAIN+2AD+1M-ANW1-EN-E1,44 • 07.97
18
1. Commissioning INDRAMAT AC Main Spindle Drives
Sollwertbox
controlller
4
1 (E1)
2 (E2)
X4
5 (E3)
6 (E4)
7 0V
8 -15V
9 +15V
1 0V ext
2 0V int
3 AS (KDA/TDA only)
18 +24V int
19 +24V ext
23 E-STOP
24 RF
25 RUN
X2
command value box
R
1
R
2
S2
S1
10k
1k
V
+/- 10V
R 1 : 10-speed potentiometer for U comm
R 2 : protective resistor
S
1 : 3-pin switch
S
2 : switch for RF enabling signal
V: DC voltameter for display
1
5
6
9
119
20 37
37-pin Cannon plug
9-pin Cannon plug
soldering side
soldering side
soldering contact soldering contact
( RAC only)
1.3 The Equipment Required
The following equipment is needed for commissioning:
• DC and AC multimeter
• command value box (analogue command value)
• 37-pin subminiature connector
• 9-pin subminiature connector
• 10-pin plug terminal block (RAC only)
Figure 5: Circuit for operating the drive with the above equipment (command value
box and subminiature connectors)