Specifications

111
• DOK-DIAX01-MAIN+2AD+1M-ANW1-EN-E1,44 • 07.97
5.3 Motor Parameters (M Parameters)
The motor parameter values are set at the factory and guarantee the
characteristics that are specified for the drive (motor controller
programming module).
The M parameter values may only be changed by trained personnel. The
drive could otherwise be damaged. An exception is the MOTFUNCT
parameter in drives with RAC.
5. Overview of Parameters
Para
-
Motor
Parameter protocol!
☞
Parameter
M01
M02
M03
M04
M05
M06
M07
M08
M09
M10
M11
M12
M13
M14
M15
M16
Designation
POLES
FEEDBACK
T-FILTER
SLIP-LIM
FLUX
CURRENT
SIGNSLIP
SIGN RPM
I-U RPM
SIGN VOLT
BETA
PHI
VOLT FACT
SLIP FACT
MOT FUNCT
PHI FACT
Function
pole number of the motor
feedback type
tachometer filter
slip limit is multiple of SIGN SLIP
magnetizing current (peak value in A)
maximum motor current (peak value in A)
characteristic slip of the drive
speed for increasing slip
speed for switching to voltage control
idle voltage of drive at 1500 rpm
corrective factor to adjust phase angle
in field control range
corrective angle for transition to
field control range
factor for load-dependent increase in voltage
factor for increase in slip in
field control range
see function table for M15
factor for transition to basic speed
range in field control range
Value range or value
2,4,6,8
1.....4
0.....3
1.0.....7.9
1.....I
type
1.....I
type
0.....300
100.....9999
100.....9999
0.....999
0.....9.99
0.....45
0.....1.0
0.....1.0
∑ < >
0.....9.99
( A )
( A )
(1/min)
(1/min)
(1/min)
( V )
( degrees)
See section
3.7
Figure 103: Overview of motor parameter (M)