Specifications

107
• DOK-DIAX01-MAIN+2AD+1M-ANW1-EN-E1,44 • 07.97
5. Overview of Parameters
Fkt-TabelleA05
Additions list!
☞
Function
torque limit if control input
MD-RED is on 1
analogue speed command value
below value in parameter MIN RPM (A03)
is invalid (drift prevention)
torque off if speed less than
value in parameter
MIN RPM (A03)
an existing second encoder input
is being ignored ( type code field
" 2nd encoder input " = P )
braking of the motor without overshoot
(speed command dependent
switch off of I-amplification of the
N-control unit)
After powering up, power
P = U
D
*
I
D is switched to
analogue output N
Master drive, analogue output N
constantly issues speed command value
After switching on, the motor temperature
T is switched ot analogue output N
Signal output N = CMD remains
active even without RF signal
(control input RF = 0 )
Change in definition of parameter
MAX DEV (A04), speed deviation
equals MAX DEV * 0.1%
of current speed command value
Function
Torque and power limit
if control output
MD-RED is on 1
analogue speed command
value is always 1
no speed-dependent
torque switch off
positioning on spindle
if 2nd encoder input present,
otherwise on motor shaft
drive overshoots during braking
as I amplification of the N control
unit is always active
after power up, speed N is
switched to analogue output N
(basic state)
analogue output N can be switched
via user interface (see 2.2.2)
after power up, speed N is
switched to analogue output N
(basic state)
signal output N = CMD is only
active with drive running
the value of parameter MAX DEV
means ( 1 / min )
< 1 >
< 2 >
< 4 >
< 8 >
< 16 >
< 32 >
< 64 >
< 128 >
< 256 >
< 512 >
< 1024 >
< 0 >
< 0 >
< 0 >
< 0 >
< 0 >
< 0 >
< 0 >
< 0 >
< 0 >
< 0 >
< 0 >
Relevant summand
3.9
3.3
3.3
3.6.4
3.7
2.2.2
3.17
2.2.2
3.3
3.3
3.2.2
See section
no change in value of the
digital speed command value
A 01
N
comm
A 01
= • N
comm
digital
16383
Figure 99: Function table for parameter FUNCT1 (A05)