Specifications

106
• DOK-DIAX01-MAIN+2AD+1M-ANW1-EN-E1,44 • 07.97
5. Overview of Parameters
Note:
The totals of the summands (∑<>) assigned to the functions should be
entered as parameter values of the function parameters FUNCT1 (A05)
and FUNCT2 (A06) (see functions table). An additions list is added to the
parameter list for recording the necessary summands.
Para-allgemein
Parameter protocol !
☞
Parameter
A01
A02
A03
A04
A05
A06
A07
A08
A09
A10
A11
A12
A13
A14
A15
A16
A17
A18
A19
A20
Designation
MAX RPM
CMD VOLT
MIN RPM
MAX DEF
FUNCT 1
FUNCT 2
OFFSET
POS 1
POS 2
POS 3
ENCODER
LIMIT 1
LIMIT 2
LIMIT 3
LIMIT 4
LIMIT 5
LIMIT 6
LIMIT 7
BAUDRATE
OSCI RPM
Function
maximum motor speed
analogue voltage for MAX RPM
if speed command and motor speed are below
MIN RPM then signal output "N < MIN" goes to 1
maximum speed deviation from command value
within signal output " N = CMD " goes to 1
see function table for A05
see function table for A06
phase offset of the zero impulse
spindle position 1
spindle position 2
spindle position 3
resolution of the spindle position encoder or
i.d. of Indramat encoder
maximum spindle speed 1
maximum spindle speed 2
maximum spindle speed 3
maximum spindle speed 4
maximum spindle speed 5
maximum spindle speedl 6
maximum spindle speed 7
transmission rate for serial interface
oscillating speed for gear switches
Value range or value
1.....24000
6.....10
1.....999
1.....999
0.....9999
0.....9999
0.....360,0°
0.....360.0°
0.....360.0°
0.....360.0°
128,256,512,1024,2048,
4096,8192, 3 or 4
1.....24000
1.....24000
1.....24000
1.....24000
1.....24000
1.....24000
1.....24000
1.....200
(1/min)
( V )
(1/min)
(1/min)
( ∑ < > )
( ∑ < > )
( deg.)
( deg.)
( deg.)
( deg.)
(1/min)
(1/min)
(1/min)
(1/min)
(1/min)
(1/min)
(1/min)
(1/min)
See sec.
3.2
3.2
3.3
3.3
3.6.1
3.6.1
3.6.1
3.6.1
3.6.4
3.12
3.12
3.12
3.12
3.12
3.12
3.12
3.23
3.15
50,75,110,150,300,600,
1200,2400,4800,9600,19200
sum
sum
5. Overview of Parameters
5.1 General Parameters (A Parameters)
The general parameters are always active when the drive is in operation.
Changes can only be made to parameter alues in the parameter mode.
When the parameter mode is selected, the drive brakes to the set ramps
and is then free of torque.
Figure 98: Overview of general parameters (A)