Installation Instructions for the 0D850 Outdoor Microwave Intrusion Detector 1.0 Description The ODDS Pi Microwave intrusion detector that can be mounted outdoors, if provides reasonable levels of false lama immunity and catch performance in a wide range of weather conditions. 2.0 Specifications + Dimensions (HxWxD): 6.5in. x 3.25in. x 2.25 in. {18.5 om x 8.28 10-15 VDC @ 22 mA standby. Use only an Approved Limited Power Source. No internal standby battery.
{see Figure 2d). complete the following mounting procedure. Then, using an appropriate screw, fasten the previously knocked out Tamper Section to the wall in the area of the Mounting Plate from which it was removed. NOTE: With the Tamper section broken away from the Mounting Plate and fastened to the wall, the normally-closed Tamper Switch {see Figure 2b) will be activated {opened) when the unit is pulled away from the wall, «for a cover tamper, do not knock out the Tamper section.
walk tats. During the warm-up period, the tricolor LED Figure 1 Coverage Patterns will flash red unit the unit has stabilized (approximately one to two minutes) and has seen no movement for two seconds. When the LED stops flashing, the detector is ready to be tested, With no motion in the protection area, the LED should be OFF. if the LED is on, recheck the nu protection area for disturbances affecting the microwave {yellow} or PIR {green) technologies.
Figure 2 Assembly Figure 3a Figure 3b B328 Figure 3¢ Baas Figure 3d B338 Pate Mounting Bracket Mounting Bracket Mounting Bracket Mounting Detection Systems, Inc.
