Operating Instructions

72 BTR-30N, TR-30N, TR-32N
BTR-30N Menu Structure
11/05/19 Rev 1
Page 1 of 1
GP/CH Select
Intercom Settings
Base Main
Group/Frequency Select
<MENU>
<SET>
<SET>
<SET>
<SET>
<MENU>
NOTES:
1. If editing any screen, pressing <MENU> once, ends editing without saving
changes, and displays current screen with nothing flashing. The only exceptions are the Group/Ch, Group/Freq., and Freq. edit screens where a <MENU> press does save frequencies and places unit on those frequencies.
2. Pressing <MENU> in any screen where no editing is occurring returns unit to
status screen.
3. If an entry is set to “off” that has level setting values following, skip the level
settings.
4. Status screen RX options: OFF, NoTx, Ch 1, Ch 2, Ch12, WT 1, WT 2, WT12,
SA
5. TX power options: Off, 10, 50, 100, 249mW 6. Antenna power options: On, Off 7. 2W Intercom types: Telex, RTS, Clear-Com, Off 8. 2W Intercom channels: On, Off 9. Aux IC Mode options: Off, Local, Global 10. 4W IC1 and IC2 options: On, Off 11. All screens default to status screen after 5 minutes except RSSI screen. If RSSI
screen is selected the unit stays on that screen until user switches it back.
BTR-30N Menu Structure
Status Screen
Aux Settings
Group/Channel Select
RSSI Screen
Start-up Screen
<SET>
<SET>
<MENU>
+
<SET>
held for 2 seconds
NOTE: From any screen
<SET> Does set results
Display
Contrast
Adjust
OR
Status Screen
Frequency Edit
<MENU>
(User-Programmed Groups Only)
(Factory Groups Only)
<MENU>
Status Screen
<MENU> or <SET>
save settings
Local Headset
TX Power
<SET>
<SET>
<SET>
Special Key Sequences:
1. Lockout: Press and hold <UP> + <DOWN> for 2 seconds. 2. Copy: Press and hold <SET> + <DOWN> for 2 seconds. 3. 1
st
Use Default: Press <MENU> while turning on the base station.
4. Factory Default: Press and hold <MENU> + <SET> + <UP> + <DOWN> for 2 seconds. NOTE:
After holding the button for 2 seconds, the screen will change to the desired screen before the
button release.
<SET>
<SET>
<SET>
<SET>
<MENU> Held for 2
seconds to enter
<MENU> Does NOT set results
<MENU> + <UP>
For quick frequency
display / edit
<SET>
<SET>
<SET>
<SET>
<MENU> Tap to
return