Operating Instructions

BTR-30N, TR-30N, TR-32N Operation 55
l
On/Off and Volume Control
To turn the beltpack power on, do the following:
>
Rotate the On/Off Volume Control knob(s) CW.
To adjust the volume to the headset, do the following:
>
Rotate the On/Off Volume Control knob as required
for a comfortable listening volume.
TALK Button
To enable the audio path from the headset microphone, do
the following:
>
Press the TALK button.
The talk light activates when the TALK button is
active.The TALK button has three (3) software
selectable modes that can be seen via the LCD display
of the beltpack.
To select the TALK button mode, do the following:
1.
Press and hold SET while pressing the TALK button.
The current mode of the TALK button displays the first time
the TALK button is hit. Pressing the TALK button a second
time changes the mode of the button.
2.
Release SET to accept the currently displayed setting.
Audio Channel Select Button
To select which intercom system the headset connects to, do
the following:
1.
Press and hold SET while pressing the CHANNEL select
button.
The current mode of the CHANNEL select button displays
the first time the button is hit. Pressing the button a second
time changes the mode of the button.
2.
Release SET to accept the currently displayed setting.
FIGURE 72.
TR-30N Top Panel Controls
Batt/PK LED Status
Battery Light flashes on power up =Battery OK
Light on continuously =Battery Low
Light does not flash/power on =Battery Dead
Over
modulation
Light flashes on some speech =Gain OK
Light flashes on all speech =Gain too high
Light never flashes on speech =Gain too low
Selectable Modes:
TALK
tb off Talk disabled
tb Ptt Push-to-talk
tb LAt Push-to-latch
Selectable Modes:
Audio CHANNEL
Button 12 on Channels 1 and 2
available
1 on Only channel 1
2 on Only channel 2