Operating Instructions

BTR-30N, TR-30N, TR-32N Operation 37
2-Wire Intercom
The screens below show the progression of setting 2-wire
parameters.
To adjust
the 2-wire intercom settings, do the following:
1.
From the status screen, press the MENU button.
2.
Using the UP/DOWN arrow buttons, select Intercom
Settings.
3.
Press SET.
4.
Using the UP /DOWN arrow buttons, select 2-W.
5.
Press SET.
The 2-wire intercom type flashes.
6.
Using the UP/DOWN arrow buttons, set the intercom type.
7.
When finished, press SET.
The intercom channel flashes.
NOTE: If off is selected, the 2-W/4-W menu options
appear.
8.
Using the UP/DOWN arrow buttons, select the intercom
setup–intercom 1, intercom 2, or both.
9.
Press SET.
The intercom input level flashes.
10.
Using the UP/DOWN arrow buttons, select the input level.
11.
When finished, press SET.
12.
Proceed through the intercom settings.
Once finished, the screen display returns to the 2-W/4-W
selection menu.
13.
Press MENU twice to go back to the status screen.
NOTE: The base defaults back to the status screen if no
action is taken after five (5) minutes.
4-Wire Intercom
The screens below show the progression of setting 4-wire
parameters.
To adjust the 4-wire intercom settings, do the following:
1.
From the status screen, press the MENU button.
2.
Using the UP/DOWN arrow buttons, select Intercom
Settings.
3.
Press SET.
4.
Using the UP /DOWN arrow buttons, select 4-W.
5.
Press SET.
The intercom one 4-wire on/off selection flashes.
6.
Using the UP/DOWN arrow buttons, select on or off.
7.
When finished, press SET.
The intercom input level flashes.
NOTE: If off is selected, the screen skips to the intercom
two screen.
8.
Using the UP/DOWN arrow buttons, select the intercom
setup–intercom 1, intercom 2, or both.
9.
Press SET.
The intercom input level flashes.
10.
Using the UP/DOWN arrow buttons, select the input level.
11.
When finished, press SET.
12.
Proceed through the intercom output settings in a similar
manner.
Once finished, the intercom two 4-wire on/off selection
flashes.
13.
Repeat steps 6-12 for intercom two.
Once finished, the screen display returns to the 2-W/4-W
selection menu.
14.
Press MENU twice to return to the status screen.
NOTE: The base defaults back to the status screen if no
action is taken after five (5) minutes.
FIGURE 49.
2-Wire Intercoms
FIGURE 50.
4-Wire Intercoms