User's Manual

88 Basic Operation ROAMEO System
Bosch Security Systems, Inc.
Technical Manual
F.01U.306.750
Rev. 01
Latching vs Momentary Key Operation
Latching is used to enable or disable the beltpack button to stay on when pressed. When Latching is enabled, the talk function
stays on after the talk button is pressed. Momentary button operation works by pressing and holding the button to operate.
Once the button is released, the button is no longer active.
To latch a button on, do the following:
> Tap the button to latch on.
The button latches on.
To unlatch a latched button, do the following:
> Tap the latched button to unlatch.
The button unlatches.
To operate a button in momentary mode, do the following:
1. Press and hold the button for at least 0.5 second.
2. Release the button to turn the key off.
Pages
Setup Pages are used to set up additional button assignments on the beltpack. The beltpack has four pages with four button
assignments per page, giving a possible 16 assignments available. Pages provide the user the ability to quickly configure the
alphas of the talk/listen buttons to another set of predefined alphas. Beltpack pages are defined by a user in the AZedit
software and may be easily recalled by the beltpacks via the UP/DOWN and SELECT buttons from the home screen.
To set up Pages in AZedit, do the following:
NOTE: While editing Setup or Advanced settings, click Apply at any time to enter the changes.
1. In the Port field, enter the port number.
OR
From the Alpha drop down menu, select the port name (alpha).
2. Press Enter.
The port is now selected.
3. From the page drop down menu, select the page you want to configure.
4. From the Setup Page group box drop down menu for the TR-1800, select Setup Page 1.
The talk/listen fields on the Keypanel/Ports page become active.
5. Press the OK button.
The Keypanel/Port Configuration window closes.
6. In the listen/talk field, define the button assignments for the page.
7. Repeat steps 3 through 8 to populate pages 2 through 4, if desired.
8. When finished, click Send Changes to send the changes to the matrix.