User's Manual

62 Installation ROAMEO System
Bosch Security Systems, Inc.
Technical Manual
F.01U.306.750
Rev. 01
Configure the AP-1800 in IPedit
To configure the Access Point with IPedit, do the following:
IMPORTANT: The user must be signed in to IPedit with network administrator rights to complete these instructions.
1. From the Device Catalog on the left, select the AP-1800.
The Device Information pane populates.
2. In the Description field, enter a unique description for the access point.
3. In the Version field, verify the version information is correct.
4. Verify the IP Address is correct, if using a Static IP Address.
5. Select the Disable RSTP check box to disable the RSTP protocol, if desired.
DECT Information
6. In the System ID field, enter the system ID for the access point. This field accepts a 3-digit hexadecimal number. By
default, this field is set to B2B.
NOTE: All access points in a system must have the same System ID.
7. In the AP ID field, enter the unique AP ID for the access point. The range for this field is 1–254.
8. Select the Sync Master check box if the access point is the master for the entire system.
NOTE: There can be only one master in each system.