User's Manual

40 Site Survey ROAMEO System
Bosch Security Systems, Inc.
Technical Manual
F.01U.306.750
Rev. 01
Set Up an Existing System with a Static IP Address
To set the computer to a Link Local IP Address, do the following:
IMPORTANT: These instructions detail a typical setup for the Windows 7 platform.
NOTE: If the AP-1800 has been connected to a Matrix system in the past or assigned a static IP Address already, then
assigning the computer a Link Local Address will not work. If the AP-1800’s IP Address is known, configure the
computer to be in its network. If the IP Address is unknown, then reset the AP-1800 back to a Link Local
Address by performing a factory reset, see “Factory Default Reset” on page 144.
1. From the Start menu, select Control Panel.
2. Click Network and Internet.
The Network and Internet window appears.