User's Manual
Table Of Contents
- ROAMEO Family Wireless Intercom System
- •TR-1800 •AP-1800
- CHAPTER 1 Certification Information
- CHAPTER 2 Introduction
- CHAPTER 3 System Overview
- CHAPTER 4 Site Survey
- CHAPTER 5 Installation
- CHAPTER 6 Basic Operation
- CHAPTER 7 Beltpack Overview
- System Quick Start
- Button Operation – Common
- Menu Structure – Main Menu Access
- Aux Input Menu
- AUX DIM Menu
- Volume Limit Menu
- Headset Select Menu
- Mic Gain
- Sidetone
- Mic Noise Gate
- Hot Mic
- Talk/Listen LED Buttons
- Front Display Brightness
- Top Display Brightness
- LCD Timeout
- Call Tally Talk
- Screen Flip
- Master Talk Switch
- Low Battery Alert
- Call Waiting Alert
- DECT Connection Alert
- Matrix Connection Alert
- Dark Mode Boot Alert
- Key Clicks Alert
- Alerts Levels
- Key Assignments
- Icon Help
- Scroll List
- CHAPTER 8 Access Point Overview
- AP-1800 Front Panel Description
- IPedit Requirements
- IPedit Main Window
- Configuration
- Device Name Field
- Description Field
- Version Field
- IP Address Field
- Netmask Field
- Gateway Address Field
- DNS Server Field
- Domain Name Field
- MAC Address Field
- Use Static IP Settings Check Box
- Disable RSTP Check Box
- Type Field
- Status Field
- Sessions Field
- AP Channels Field
- BP Channels Field
- Sync Display Box
- System ID Field
- PIN Field
- Zone Drop Down Menu
- CODEC Drop Down Menu
- AP ID Number Field
- Sync Master Check Box
- Intercom Alpha Field
- Channel Description Field
- Destination Type Drop Down Menu
- Destination Device Name Field (OMNEO devices and AP-1800 ROAMEO Access Point Only)
- Destination IP Address Field
- Destination Description Field
- Destination Channel Drop Down Menu
- Destination Channel Description Field
- Receiver Latency Field
- DECT BPID
- DECT Zone Selection Field
- Configuration
- CHAPTER 9 Maintenance
- CHAPTER 10 Troubleshooting, Accessories and Replacements
ROAMEO System Troubleshooting, Accessories and Replacements 155
Bosch Security Systems, Inc.
Technical Manual
F.01U.306.750
Rev. 01
Accessories and Replacement Parts
Cannot download
firmware to the
access point
• The computer where the
FWUT (Firmware Update
Tool) is located is not in the
same network as the access
points.
• If the matrix system containing the access points is
configured for DHCP addressing, then the computer where
the Firmware Upload Tool resides should also be
configured for DHCP addressing.
• If the matrix system containing the access points is
configured with a static IP Address, the computer where the
Firmware Upload Tool resides should be assigned an IP
address within the Matrix’s network.
• Ethernet cable to access
point is disconnected.
• Check that the Ethernet cable to the AP is connected. There
should be blinking activity on the left yellow LED on the
AP’s RJ-45 port to which the cable is connected. The AP
should also display a green light near the power jack.
TABLE 5. Accessories and Replacement Parts
Name Description Model
Antenna Dipole-type antenna with reverse polarity,
SMA plug, and swivel base used for the
AP-1800 access point.
ANT-1800
BP-240 Battery 7.5V, Li-Ion battery for the TR-1800
beltpack.
BP-240
CHG-240 4-Bay
Charger
4-bay charger to charge four BP-240
Lithium Ion batteries in parallel.
CHG-240
Issue Possible Cause Solution