User's Manual

144 Maintenance ROAMEO System
Bosch Security Systems, Inc.
Technical Manual
F.01U.306.750
Rev. 01
Access Point Reset – Factory Default or Normal
Factory Default Reset
Factory Default Reset is used to set the access point to the factory defaults.
To perform a factory default reset, do the following:
1. Press and hold the reset button for 10 seconds.
The LED starts blinking orange, indicating the device is in factory reset mode.
IMPORTANT: The unit aborts the reset, if the reset button is not pressed for any three (3) second gap.
2. Release the reset button.
3. Press and hold the reset button for another 10 seconds to confirm the factory default reset.
LED starts blinking red, indicating the defaults being restored.
4. Release the reset button.
The unit resets and powers up with the factory defaults.
Normal Reset
A Normal Reset reboots the access point without making any changes to the configurations.
To perform a normal reset, do the following:
1. Press and hold the reset button for three (3) seconds.
The LED starts blinking green, indicating normal reset mode.
2. Release the reset button to reset.
The access point resets.