User's Manual

94 Beltpack Overview ROAMEO System
Bosch Security Systems, Inc.
Technical Manual
F.01U.306.750
Rev. 01
Button Operation – Common
Power Button
The Power button is used to turn the beltpack on and off.
Power On the Beltpack
On power up, the beltpack initiates a scan for an access point with a valid DECT system ID, a strong signal, a system where it
has been subscribed, a valid zone and channel availability.
To power on the beltpack, do the following:
> Press the power button momentarily.
The beltpack turns on. The talk/listen buttons on the top panel of the beltpack blink green and then blink red. The top
and front displays light. The beltpack starts a scan for a valid DECT System ID, beltpack slots available, the
strongest signal, and a valid zone for the beltpack to operate.
To turn off the beltpack, do the following:
> Press and hold the power button for two seconds.
The beltpack turns off.
FIGURE 20. Front Controls