User's Manual

70 Installation ROAMEO System
Bosch Security Systems, Inc.
Technical Manual
F.01U.306.750
Rev. 01
Subscribe the Beltpack and Connect to the Access Point
IMPORTANT: An access point must be configured using IPedit before a beltpack can be subscribed with a system.
To subscribe the beltpack, do the following:
1. Press the power button to turn the beltpack on.
An unsubscribed beltpack powers up with the System Setup screen appears.
NOTE: A subscribed beltpack can access this setup screen through the beltpack menus. For more information, see
“Subscribe the TR-1800 to the AP-1800” on page 44.
2. From the System Setup screen, press the SELECT button on the front of the beltpack.
The system ID screen appears.
NOTE: If it becomes apparent that no access points can be found, the MENU key may be used to return to the
System Setup screen to try again.
3. Using the UP and DOWN buttons, enter the first digit of the System ID.
4. Press the SELECT button.
The focus moves to the next field in the system ID.
NOTE: The SELECT button advances the focus to the next field. The MENU button goes back one field.
5. Repeat step 3 and step 4 until the system ID is entered.
6. Press the SELECT button.
The beltpack begins scanning for active access points with its RF coverage area. The search process can take several
seconds. When an access point is found, the PIN entry screen displays.