User's Manual

ROAMEO System Installation 59
Bosch Security Systems, Inc.
Technical Manual
F.01U.306.750
Rev. 01
Connecting the Access Point to the Intercom
The OMI card is configured using AZedit and IPedit; however, only IPedit can be used to configure the access point.
IMPORTANT: Verify the computer is connected to the same network as the Intercom Matrix frame.
Configure the OMI using AZedit
To configure the OMI to the Access Point using AZedit, do the following:
1. From the Status menu in AZedit, select I/O Cards.
The I/O Card Status window appears showing a list of installed cards.
2. Right-click the OMI card to configure to the AP-1800.
A pop-up menu appears.
3. From the pop-up menu, select OMNEO Configuration.
The OMNEO Configuration window appears.
4. From the OMNEO card drop down menu, select the slot number where the OMI card is located in the frame.
The device Name field auto-populates with the name of the device.
5. From the Local Channel drop down menu, select the channel to use to communicate to the AP-1800 across the
network.
NOTE: Channels not already configured to connect to another device appear with an asterisk (*) next to them.
6. In the Partner Device Name field, enter the name of the AP-1800 to communicate with or select the Browse icon to
select from a list of devices.
OR
In the Partner IP Address field, enter the IP Address of the device to make a connection.
This field auto-populates when the Device Name is selected.
7. From the Partner Device Type drop down menu, select the type of device to which the OMI card is connecting.
8. From the Partner Channel drop down menu, select the channel on the device to which the OMI communicates.
9. When finished, click Apply.
Apply sends all the changes to all the cards in the intercoms or click Cancel to discard all the changes made.