User's Manual

ROAMEO System Maintenance 145
Bosch Security Systems, Inc.
Technical Manual
F.01U.306.750
Rev. 01
TBR-6 Test Mode
IMPORTANT: TBR-6 Test Mode is for agency testing only.
To enter test mode, do the following:
1. Press and hold the reset button for 20 seconds.
The LED starts to flash green, then flashes orange, and then a fast blinking orange to indicate the unit is in Test Mode.
This occurs within the 20 seconds the reset button is held.
2. Release the reset button and within 3 seconds press and release it again.
The LED repeats a red blinking sequence to indicate the unit is running in the TBR-6 test mode.
IMPORTANT: To get the access point out of TBR-6 test mode, cycle the power to the device. The access point reboots
into normal mode.
Beltpack
Update the Firmware on the TR-1800 ROAMEO Beltpack
If problems are encountered, see “Cannot download the firmware update to the beltpack” on page 154.
To update the TR-1800 ROAMEO beltpack firmware, do the following:
1. On the front of the beltpack, press the MENU button.
The HOME screen appears.
2. Press the MENU button again.
The MENU icons appear in the beltpack display screen.
3. Using the DOWN arrow button, navigate to the Settings icon.
4. Press the SELECT button.
The Settings submenu icons appear in the beltpack display screen.
5. Using the DOWN arrow button, navigate to the Update icon.
6. Press the SELECT button.
Application, Unicode Fonts, Splash Image, and DECT module appear in the beltpack display screen.
7. Using the DOWN arrow button, navigate to the firmware item to be updated.
8. Press the SELECT button.
The message Plug in the USB Stick appears in the beltpack display screen.
9. Plug the approved USB into the bottom panel USB connector. See Figure 1 on page 16.
A list of current firmware appears in the beltpack display screen.
10. Using the UP and DOWN arrow buttons, select the firmware to upload.
11. Press the SELECT button.
An updating message and a progression bar appear on the beltpack display screen.
12. Remove the USB stick.