User's Manual

142 Maintenance ROAMEO System
Bosch Security Systems, Inc.
Technical Manual
F.01U.306.750
Rev. 01
IMPORTANT: Each beltpack connected to the Access Point must re-subscribe to the system before it can connect to
the access point.
Add an Access Point to the System
To add an access point to the system, do the following:
Step 1 Configure each Access Point to the OMI.
Step 2 Using IPedit, configure the access point to have the same System ID, the same CODEC as the system, and
pick a unique AP ID.
IMPORTANT: The Sync Master check box is not selected if another access point is assigned as the sync master for the
system.
Step 3 If applicable, set up the channel configuration settings (only necessary if a beltpack is going to use the
access point as HOME).
Step 4 If applicable, assign a zone.
Step 5 Send Changes.
Step 6 If applicable, subscribe a beltpack.
Reboot the Access Point
To reboot the Access Point, do the following:
1. Unplug the power cord from the AP-1800.
The AP-1800 turns off.
2. Plug the power cord into the device.
The AP-1800 turns on and runs through its LED cycle.