User's Manual

136 Access Point Overview ROAMEO System
Bosch Security Systems, Inc.
Technical Manual
F.01U.306.750
Rev. 01
Receiver Latency Field
The Receiver Latency field displays the current latency of the OMNEO packets to the access point from the Matrix.
DECT BPID
The DECT BPID field is used to enter the unique identifier for the beltpack. This identifier is displayed on the beltpack when
it is powered on. When this identifier is entered into IPedit, this establishes the beltpack’s home access point. Once this home
access point is established, and the AP OMNEO channel is linked to an OMI card, the alpha of that beltpack is established.
This field is used to enter a 10-digit hexadecimal number that identifies the beltpack in the system.
The following format must be used: BP00:09:23:A2:28
DECT Zone Selection Field
The DECT Zone selection field is used to select the zones that a beltpack has access. There are eight zones available. Zones
provide a way to prioritize which beltpacks can roam or attach to which access points.
NOTE: Leaving the system at the default settings (zone 1) allows every beltpacks to roam and attach to all access points
in a system
A beltpack must be a member of at least one zone and can be assigned up to as many as eight zones. Access points can be
assigned to only one zone.
IMPORTANT: Access to the Zone Selection field requires Administrative privileges.
For more information on configuring the access point, see “Access Point” on page 137.
To select a zone, do the following:
1. From the Channel column, select the Zone field.
2. Using the number keys on the keyboard, select the desired zones the beltpack can roam and access.
To deselect a zone, do the following:
> Using the number keys on the keyboard, select the zone number to deselect.