User's Manual
Table Of Contents
- Telex Model RKP-4 Beltpack
- The Telex model RKP-4 beltpack transceiver is a component of
- A RKP-4B base station can be used with one RKP-4 beltpack.
- Typical transmitter conducted output power is 50 mW. The RKP
- Operating frequencies can be selected from pre-set groups or
- Transmit and receive antennas are attached to the RKP-4. Eit
1. On/Off & Volume Control – Turns the beltpack power on and controls
headset volume.
2. [UP] and [DOWN] buttons - Used to select menus and set options on the
LCD.
3. LCD display.
4. BAT/O.M. Light –
Battery - Light flashes on power up = Battery OK
Light on continuously = Battery Low
Light does not flash or come on = Battery Dead
Microphone Lvl: Light flashes on loudest speech = Gain OK
Light flashes on all speech = Gain too High
Light never flashes on loudest speech = Gain too Low
5. [COPY] button – Used to assign incoming calls from a digital matrix to
front panel talk and listen buttons.
6. Listen Buttons –Used to listen to audio from the assigned matrix user for
that button
7. Talk Buttons – Used to talk to the assigned matrix user for that button.
Controls and Connections
5
4
8. [MENU] and [SET] buttons – Used to select menus and set options
on the LCD.
9. LCD display.
10. [UP] and [DOWN] buttons - Used to select menus and set options on
the LCD.
11. Push-to-Talk/Push-to-Transmit Switch – Does nothing in the RKP-
4. The transmitter is always up.
12. Headset Connector – XLR Plug for Telex units, XLR Receptacle for
RTS units.
13. Battery Latch – Press down to enable the battery pack to be released.
While the latch is held down, slide the battery pack about 1/8 inch
back, toward the latch, until it stops, then lift out.
14. Receive and Transmit Antennas – The antennas are screw type, ¼
wave, replaceable antennas. The color dot on the screw end of the
antenna must match color dot on antenna receptacle.
3
2
1
8
9
6
10
7
11
12
13
14
Page 2 of 3