User Manual

Telex SAFE-1000 Page 7
Quick Set-up: Receiver.
1. Do not connect the receiver to any other equipment yet!
2. Connect the Antennas to the receiver.
3. Plug the Wall supply output cord into the receiver 12-15V input jack.
4. Plug the AC Wall supply into a 120 VAC Outlet.
5. Press the POWER switch. Display should light.
6. Display shows Telex name and software versions for about 3 seconds
then displays the 1st operating screen. Note the GP (Group Number)
and CH (Channel Number). Also note if the RF Bar Scale (1-100) is
displaying any Reading over about 3 to 10. If so this indicates RF
interferance and you should change Group/Channels before
proceeding.
7. Press the Menu button until the Display shows the Squelch setting.
Should be near the U in squelch. If the squelch bar is not seen or is at
extreme left, proceed to step 13 for setting the squelch. Skipping step
13 may cause loud white noise in the audio system!!
8. Press the Menu Button one more time. The first operating screen
appears again.
9. Press the Power switch on the receiver front panel to turn the unit off.
10. Plug the mixer or other audio system into the receiver XLR
Microphone Level Connector or into the ¼ inch Line Level Jack. Set
the Line Level Control near the ¼ inch jack to about 50 % of rotation.
11. Insure that the audio mixer or other system input level is turned down.
12. Press the Power switch button in again. The 1
st
operating screen
should appear in about 3 seconds. The receiver should be ready to
operate unless the squelch requires setting as in step 13.
13. The SQUELCH Screen will show a rectangular box with SQUELCH”
above it.To change or open the squelch, press SET once. This starts
the display flashing. Press and hold the UP or DOWN Button as long
as required to place the squelch bar in the desired position. The
factory setting with the bar ending under the “U” of the squelch label
is recommended. When the setting is complete, press SET once. Press
the Menu Button as required to go to a new screen.