User Manual

TELEX SAFE-1000 Page 6
SYSTEM PROGRAMMING
The SAFE-1000 System uses the same basic programming steps in the
Receiver and Transmitters. Learning these basic steps early will save time
and effort.
SCREENS: Computer controlled screens will advance or return
automatically. The software version screens will stay on for
about 3 seconds after power is applied. To see them again, you
must turn power OFF and then ON again.
MENU: Pressing this “key” once will advance the current screen to the
next screen.This key will also perform a “SET” operation as the
current screen is left. To review the various screen status, press
the key to advance screens. No change to screens will occur
unless the “SET” Key is pressed.
SET: This key is used to initiate any change to the screen currently
being viewed. Flashing (blinking) characters will be seen after
the SET Key is pressed. The flashing characters can be changed
by use of the “Arrow” Keys or accepted as is by using the SET
key. Use the MENU Key to exit the current screen. Exiting a
screen with the MENU Key terminates any flashing operation.
ARROW: These keys are used to make changes to the screen currently
being viewed. The keys are not active until SET is pressed, with
one exception. When the SQUELCH screen is displayed, the
squelch bar can be changed with the Arrow Keys without
pressing SET. Exiting the SQUELCH Screen by pressing
MENU saves the setting.
Power: Removing power from any unit saves the last operation of all
screens.
Other: All other unit controls are manually operated.