Installation Instructions

AMEC DoC requirement
Federal Communications Commission (FCC) Rules
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference re-
ceived, including interference that may cause un-
desired operation. This equipment has been tested
and found to comply with the limits for a Class B di-
gital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable pro-
tection against harmful interference in a residential
installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instruc-
tions, may cause harmful interference to radio com-
munications. However, there is no guarantee that in-
terference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determ-
ined by turning the equipment off and on, the user
is encouraged to try to correct the interference by
one or more of the following:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications made to the product
without Bosch's consent is prohibited and may void
the user's ability to operate the equipment.
Region Agen
cy
Certification
US and
Canada
IC ISED IC ID: 1249A-EICO
RSS210, issue 9
FCC FCC ID: T3X-EICO
Industry Canada (IC) Rules
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device. Le présent
appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de
brouillage, et (2) l’utilisateur de l’appareil doit ac-
cepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le
fonctionnement.
Under Industry Canada regulations, this radio trans-
mitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
Conformément à la réglementation d’Industrie
Canada, le présent émetteur radio peut fonctionner
avec une antenne d’un type et d’un gain maximal
(ou inférieur) approuvé pour l’émetteur par Indus-
trie Canada.
Dans le but de réduire les risques de brouillage radi-
oélectrique à l’intention des autres utilisateurs, il
faut choisir le type d’antenne et son gain de sorte
que la puissance isotrope rayonnée équivalente
(p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’ét-
ablissement d’une communication satisfaisante.