User's Manual Part 1

Bosch Security Systems | 2007-11 | 9922 141 70691 en
DCN Wireless | Installation and User Instructions | Central Devices en | 60
Note:
• Flashing (fast) = one second on, one second off.
• Flashing (slow) = one sec on, three seconds off.
table 11.4: Status LEDs
Blue (A) Red (B) Blue (C) Description
Flashing (fast) Off Off The wireless mode is set to On (refer to table 10.25), and no
wireless contribution devices are connected to the system.
Flashing (fast) Off Flashing (fast) No wireless contribution devices are connected, and menu
item 3B, one of the 3B submenus, or 4Kd of the
configuration menu of the central control unit is open. Use
these menu items to configure the wireless access point
(refer to figure 10.12).
Flashing (fast) Off On The wireless mode is set to Subscription (refer to table
10.25), and no wireless contribution devices are connected
to the system.
Flashing (slow) Off Flashing (fast) The wireless mode is set to Sleep (refer to table 10.25), and
menu item 3B, one of the 3B submenus, or 4Kd of the
configuration menu of the central control unit is open. Use
these menu items to configure the wireless access point
(refer to figure 10.12).
Flashing (slow) Off Off The wireless mode is set to Sleep (refer to table 10.25).
Off Flashing (fast) Off The system prepares a software transfer to the wireless
access point.
Off Flashing
(slow)
Off The wireless mode is set to Off (refer to table 10.25), or the
power value of the wireless access point is set to Off (refer to
table 11.3). This LED sequence is also used to indicate that
the central control unit is incompatible with the wireless
access point (if this is the case, a message is also shown on
the display of the central control unit).
Off Off Off The wireless access point is off.
Off On Off The wireless access point lost connection with the optical
network.
On Flashing (fast) Off The system sends software to the wireless access point.
On Off Flashing (fast) One or more wireless contribution devices are connected to
the system, and menu item 3B, one of the 3B submenus, or
4Kd of the configuration menu of the central control unit is
open. Use these menu items to configure the wireless
access point (refer to figure 10.12).
On Off On The wireless mode is set to Subscription (refer to table
10.25), and one or more devices are connected to the
system.
On Off Off The wireless mode is On (refer to table 10.25), and one or
more wireless contribution devices are connected to the
system.
On On On Internal error in wireless access point.