User's Manual

Users
Click the Users button on the System settings page to open the Users settings page.
To add Users, click the + button to open the Add new user screen.
To change or remove Users, select a user, and use the edit icons.
For each (new) user, the following can be entered or selected:
– General: Enter First name, Last name, Username, Password (may be empty).
– User rights to be selected (the grey button color means: selected) are for example:
– Manage meeting. This right gives access to the Manage discussion and Voting
pages. Refer to Manage discussion, page 12 or Voting, page 15.
– Prepare meeting. This right gives access to the Prepare discussion and Participants
pages. Refer to Prepare discussion, page 13.
– Modify users. This right gives access to Users. Refer to Users, page 17.
– Configure. This right gives access to the System settings, System info, Logging, and
Battery and Signal pages. Refer to System settings, page 16.
– Prepare system. This right gives access to the Switch system on/off and Battery
and Signal pages. Refer to Switch system on/off, page 24.
Audio
Click the Audio button to open the Audio settings page:
– System:
– Master: Master volume control for the loudspeakers of the Wireless Devices, and the
line output of the Wireless Access Point.
– Line input/output:
– In: Sets the sensitivity of the audio line input of the Wireless Access Point.
– Out: Sets the level of the audio line output of the Wireless Access Point.
– Routing options I/O: Defines the audio routing mode of the Wireless Access Point:
– Recorder: Use this mode to connect an external recorder via the audio line input and
audio line output.
– Floor: In this mode, the level of the audio line output is “also” controlled by the
Master.
– Mix‑minus: Use this mode to connect an external telephone coupler, or two systems,
via the audio line input and audio line output.
– Insertion: Use this mode to connect external audio devices, such as audio mixers,
and audio processors.
– Public Address (PA): In this mode, the level of the audio line output is “not”
controlled by the Master.
– Feedback Prevention:
– Digital Acoustic Feedback Suppression: When selected, enables the DAFS function.
– Loudspeaker active when microphone is on: When selected, enables the
loudspeaker of the device, when the microphone is on.
– Attenuate headphone when speaking: When selected and the microphone is on,
attenuates the headphone volume of the Wireless Device 18 dB.
– Test Tone: Click the appropriate button to test the audio in the system with a 1 kHz or
Sweep tone. Click the Off button to stop the test tone.
– When Send test tone to loudspeakers is selected, generates the selected test tone
to the connected Wireless Devices loudspeaker.
5.4.1
5.4.2
DICENTIS Web interface application | en 17
Bosch Security Systems B.V. Configuration manual 2015.03 | V1.0 |