User's Manual
Table Of Contents
3. Install the Battery Pack (15) in each
Wireless Device to be used. Refer to Battery Pack ,
page 24.
4. Attach the microphones to the Wireless Devices (11). Refer to Microphones, page 22.
5. Place the Wireless Devices in the coverage area of the Wireless Access Point (DCNM-
WAP). See Installation planning, page 11, if required.
Connection, indicators and controls
The following table gives an overview of the Wireless Device items and functionality (Refer to
the numbers in the previous figure).
Connection and configuration of the Wireless Devices within the system is done via DCNM-
WAP. Refer to the software configuration manual of the DICENTIS Wireless Conference
System.
Item Description
1 Near Field Communication (NFC) reader for user identification (DCNM-WDE
only). Used to identify (logon) the participant with an NFC ID‑card or smart
phone device with NFC functionality.
2 4.3” capacitive touch screen (DCNM-WDE only).
3 Loudspeaker.
4 + 5 Combined button, depending on software configuration:
–
chairperson priority button (4). Or,
– single-use device mute button (4). Or,
– dual-use device microphone request button (5).
6 LED (lightguide) microphone request button (5).
7 Microphone request button (single-use, chairperson or dual-use mode).
8 LED (lightguide) microphone request button (7).
9 Headphone volume control.
10 3.5 mm stereo jack for headphone.
11 Microphone (input) connector.
12 Red battery‑low LED indicator. The LED is flashing when the Battery Pack of the
Wireless Device
is empty within 1 hour. Charging the Battery Pack is advised.
See Battery Pack , page 24.and Charger, page 26.
13 Yellow out‑of‑range LED indicator. The LED is on when the Wireless Device is not
(yet) connected with the Wireless Access Point
(DCNM-WAP). Move the Wireless
Device within the coverage area of the DCNM-WAP. The LED is flashing when the
Wireless Device is trying to make a connection with the Wireless Access Point
(DCNM-WAP. See Installation planning, page 11.
14 (DCNM-WLIION) Battery Pack locking clip. See Battery Pack , page 24.
15 (DCNM-WLIION) Battery Pack. See Battery Pack , page 24.
16 De‑init button. When push (>2 seconds), the subscription between the Wireless
Device
and Wireless Access Point is removed.
20 en | Installation Wireless Devices and Accessories DICENTIS
2015.02 | V1.0 | Installation Manual Bosch Security Systems B.V.