User's Manual

Installation Wireless Devices and Accessories
The Wireless Device
s are used to add participants to a discussion. See System overview, page
8, if required.
Scope of delivery
– The DCNM-WD and DCNM-WDE are shipped without (accessory) parts.
Installation
The Wireless Devices are free‑standing (table-top use). No mechanical installation, other than
the accessories as described below, is required.
!
Caution!
If a Wireless Device Extended is moved from a warm and humid environment to a cold
environment there is a possibility that some condensation can form on the display. To prevent
this from happening, make sure each Wireless Device Extended is given sufficient time to
acclimatize.
1 2 3
11
4
16 1817
5 6 7 8 9 10
9
10
12 13 14
15
DCNM-WDE and DCNM-WD top, rear and base view
!
Caution!
Do not open the
Wireless Device. Any hardware change makes the product certificates
invalid. Only qualified personnel may open the Wireless Devices.
Installation of accessories
Follow below steps to install the required accessories to, and placing of, the
Wireless Devices.
These steps are a summary:
1. Check that all equipment is available.
2. For your reference, see the Wireless Device figure and table in this section.
6
DICENTIS Installation Wireless Devices and Accessories | en 19
Bosch Security Systems B.V. Installation Manual 2015.02 | V1.0 |