User's Manual

FMR-500/RE-2 System Page 8
9. Insure that the audio mixer or other system input level is turned down.
10. Press the Power switch button in again. The receiver should be ready
to operate at this point. The audio “volume” can be adjusted to suit the
Audio system input if the Line/Mic switch is in the Line position.
Before turning up the audio system fully, proceed to the Transmitter
Set-up Section.
Handheld Transmitter set-up:
1. Install a fresh Alkaline Battery into the transmitter.
2. Insure that the Microphone Gain Control is set at about 50 % of
rotation or less.
3. Press the transmitter Power Switch.
4. The Red Low Battery Light near the display should “flash” one
time if the battery is good. If the light remains on, the battery is weak
and should be replaced. No flash at all indicates a dead battery or
no battery installed.
5. If the transmitter is in “lock-out” mode, press and hold the Up and
Down buttons for 3 seconds to release. (similar to the receiver Note:
on page 4.)
6. The screen should display the GP (Group) and CH (Channel) screen.
If the Group and Channel agree with the selected receiver Group and
Channel, proceed to the next step. If the Group and Channel do not
agree with the receiver, or you wish to change them for any reason,
proceed with this step. Press the SET switch one time. The GP
number will start flashing. Use the UP button to increase the Group
or the Down button to decrease the Group number. Press Set when
the Group desired is displayed. The Channel number will now be
flashing. Use the Up and Down buttons to select the desired channel.
Press Set when the Group and Channel is selected. Press the Set and
Up buttons at the same time to display the Battery Status or to move
to the “user defined” Frequency Set display’s. Hold Set on Power Up
to toggle from Voice to Guitar or to toggle between Guitar and
Voice.