User's Manual
FMR-500/RE-2 System      Page 5 
POWER: The Power ON/OFF button is located near the upper left corner 
 of the display screen. Press the button once to apply power, press  
 again to remove power. Removing power from any unit saves the  
 last operation of all screens. Some circuitry will remain active  
 even though power is “OFF”.  
SCREEN: When power is applied, the display screen will show the following: 
A. Group (GP), Channel (CH) and Frequency that the unit is set to. 
 (factory default setting or where last used).  
B. Voice or Guitar Mode. Normal default is set to Voice. If in Guitar 
Mode, a small guitar symbol will be shown on the display (between 
Frequency and RF). If the guitar symbol is absent, the unit is set to 
voice mode. 
C. Diversity Antenna Symbols. A small antenna symbol will be shown 
 in between CH and AF. One of two symbols will be on or “flickering”  
 between symbols, indicating diversity operation. (transmitter or user  
 must be moving (normally) before diversity action can be seen). 
D. Battery Symbol. A small battery symbol will be shown below the  
Antenna symbol. The symbol will be dark for full battery and light 
(proportional) indicating battery strength. 
E.  Clear Scan symbol. When the receiver is in Clear Scan mode, the 
symbol will be flashing. 
 Screen Options:  
To change to Guitar operation : 
 Press the Power Off button. Hold the SET button IN then press the  
Power On button. The Guitar Symbol should now be shown on the 
display. To go back to Voice operation, Press Power OFF, hold the 
Set button in and Press Power On.  
To select a Special Frequency: 
 (Other than the pre-programmed Group/Channel/Frequency), press  
 both the Set and Up buttons at the same time. The Group and Channel  
 will display dashes (“—“). Press SET and the frequency display will  
 flash. Press and release the Up button one time to increase the  
 frequency by 25 KHz. Press and release the Down button one time to  
 decrease the frequency by 25 KHz. If either the Up or Down button is  
 held In for approximately 5 seconds, the frequency change will enter  










