Installation Manual

Installation and Setup
This section provides information for system planners and configurators.
Removing the Cover
Figure 4.1: Back of Transmitter
1
Retaining Screw 2 Lower Part
Instructions
1. Remove the belt clip, if used.
2. Remove the retaining screw on the back of the enclosure.
3. Use a flat-head screwdriver to pry the lower part of the front cover away from the
enclosure.
Battery
The transmitter uses a CR2, 3 V lithium battery. The central console indicates when the
battery is low and needs replacement. Refer to Enabling and Disabling Features, page 10 for
battery polarity. The battery’s life depends on usage and enabled features.
Notice!
Batteries must not be disposed of in household waste. Please take used batteries to the local
collection points. See www.boschsecurity.com/standards for further information.
4
4.1
4.2
ALLPLEX track Personnel Transmitter Installation and Setup | en 9
Robert Bosch (SEA) Pte Ltd Installation Manual 2014.03 | V1.0.0 | DL