Installation Manual

Figure 5.2: Selecting Transmitter Radio Frequency
Diagram Radio Frequency Switch Number 1 Switch Number 2
1 304 MHz (default) OFF OFF
2 303.825 MHz OFF ON
3 433.42 MHz ON OFF
Used for Factory Reset ON ON
Notice!
Remove the battery before setting the dip switches.
Use a white marker to indicate the configured RF on the back of the transmitter after setting
the dip switches.
Changes to the dip switches should be performed by administrators only.
Once the transmitter restarts after inserting the battery, the transmitter will emit a number of
beeping tones depending on the configured RF.
Radio Frequency Number of Beeping Tones
303.825 MHz 1
304 MHz 2
433.42 MHz 3
Table 5.1: Number of Beeping Tones after Restarting
Factory Reset
Factory reset should be performed by administrators only. Set both dip switches 1 and 2 to
the ON position. While pressing the Test and Alarm buttons, the transmitter resets after
inserting the battery. If the reset is successful, there will be 3 slow consecutive beep tones
every 1 second. After a successful reset, select the transmitter RF by setting the dip switches
as described in Selecting Transmitter Radio Frequency, page 10. If the reset is unsuccessful,
there will be 2 slow consecutive beep tones every 1 second.
Refer to the following table which lists the values that are being set for the respective features
following the factory reset.
Feature Value
Transmitter Type Security
Man-Down Disabled
5.2
ALLPLEX track Personnel Transmitter Enabling and Disabling Features | en 11
Robert Bosch (SEA) Pte Ltd Installation Manual 2014.03 | V1.0.0 | DL